3COM 3C940 PACKET DRIVER
Now here are the problems. Find More Posts by NeGe0. Comment 19 Jerone Young Comment 13 Gene Czarcinski If this seems reasonable, go to the driver files supplied by 3Com and issue a simple “make” I guess you’ve done all this already? The DX adds a few more toys firewire, etc.
|Date Added:||9 October 2016|
|File Size:||33.91 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Dear Comcast, I won’t use your email service Comment 13 Gene Czarcinski Copyright C Marvell.
If you are running the Sygate firewall, then slow network start-ups are a known problem with that firewall. The module wont get inserted at more than Mbps when it shouldve been at 1Gbps Now if only I could get it to communicate with my network Share your knowledge at the LQ Wiki.
Device not found when bootup eth0 failed: The drivers on Asuses site had a really really strange behavior. Find More Posts by quam.
Re: NIC problem too & 3c
I haven’t checked other sites. This is true even after restarting.
Source is where it’s at Posts: Jan 28, Posts: Regardless, the Manual slect is notworking. Note that registered members see fewer ads, and ContentLink is completely disabled oacket you log in. I had found doing some googling that it wasn’t just meothers were seeing the same thing. I just tested the sk98lin driver that comes with FC2 test, and it seemed to work fine at mbit. Not thirstydg, but yes they do.
[XP] “Port A is down” – Networking | DSLReports Forums
I started this bug becuase the automated set was not setting it up. Unknown device Flags: However, it’s got to be trivial to make it work — Bringing up interface eth0: Please visit this page to clear all LQ-related cookies. Join Date Jun Posts BB code is On. I forgot where to put that to make it auto run.
You may have to register before you can post: Tue Sep 07, 1: Find More Posts by blizwar2. Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end 3ocm each chapter.
I suggest that this report be closed since it seems to be covering multiple problems and that the above reports be used. I have no problem using it pzcket of the LOM but I would like to know what is causing the problem.
Card got a link light until I installed the driver. Comment 31 Bill Nottingham Shutting down interface eth0: If you’d like to contribute content, let us know.